Controller E1; Code (Cei/Pri Interface View) - H3C MSR 20-20 Command Reference Manual

Example

code (CEI/PRI interface view)

Syntax
View
Parameter
Description
Example

controller e1

Syntax
View
Parameter
Description
Example
When the CE1/PRI interface is working as DCE, choose the internal clock (master)
for it. When it is working as DTE, choose the line clock for it.
# Use the internal clock as the clock source on CE1/PRI interface E1 2/0.
<Sysname> system-view
[Sysname] controller e1 2/0
[Sysname-E1 2/0] clock master
code { ami | hdb3 }
undo code
CE1/PRI interface view
ami: Adopts alternate mark inversion (AMI) line code format.
hdb3: Adopts high density bipolar 3 (HDB3) line code format.
Use the code command to set the line code format for the CE1/PRI interface.
Use the command to restore the default, that is, HDB3.
undo code
Keep the line code format of the interface in consistency with that used by the
remote device.
# Set the line code format of interface E1 2/0 to AMI.
<Sysname> system-view
[Sysname] controller e1 2/0
[Sysname-E1 2/0] code ami
controller e1 number
System view
number: CE1/PRI interface number.
Use the controller e1
# Enter E1 2/0 interface view.
<Sysname> system-view
[Sysname] controller e1 2/0
[Sysname-E1 2/0]
command to enter CE1/PRI interface view.
203