Port; Port Access Vlan - H3C MSR Series Command Reference Manual

port

Use port to assign the specified access ports to the VLAN.
Use undo port to remove the specified access ports from the VLAN.
Syntax
port interface-list
undo port interface-list
Default
All ports are in VLAN 1. All ports are access ports. However, you can manually configure the port
type. For more information, see
Views
VLAN view
Default command level
2: System level
Parameters
interface-list: Specifies an interface list, in the format of interface-list = { interface-type
interface-number1 [ to interface-type interface-number2 ] }&<1-10>, where interface-type
interface-number specifies an interface by its type and number and &<1-10> indicates that you can
specify up to 10 ports or port ranges.
Usage guidelines
This command is only applicable on access ports.
You cannot assign Layer 2 aggregate interfaces to a VLAN.
Examples
# Assign Ethernet 1/1 through Ethernet 1/3 to VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] port ethernet 1/1 to ethernet 1/3
Related commands
display vlan

port access vlan

Use port access vlan to assign the access ports to the specified VLAN.
Use undo port access vlan to restore the default.
Syntax
port access vlan vlan-id
undo port access vlan
Default
All access ports belong to VLAN 1 and do not belong to any other VLAN.
Views
Ethernet interface view, Layer 2 aggregate interface view
"port link-type."
26