Error-Diffusion Restraint Config - H3C MSR 20-20 Command Reference Manual

206 C 12: F
HAPTER UNDAMENTAL

error-diffusion restraint config

Syntax
View
Parameter
Description
CE1/PRI I C
NTERFACE ONFIGURATION
Table 17 Description on the fields of the command
Field
Line Code
Idle Code
Itf type
Itf number
Loopback
Alarm State
Historical Statistics
Last clearing of counters
Data in current interval (150 seconds
elapsed):
0 Loss Frame Alignment Secs, 0
Framing Error Secs,
0 CRC Error Secs, 0 Alarm Indication
Secs, 0 Loss-of-signals Secs,
0 Code Violations Secs, 0 Slip Secs, 0
E-Bit error Secs
error-diffusion restraint config detect-timer renew-timer threshold
undo error-diffusion restraint config
System view
detect-timer: Setting of the error packet detect timer, in the range 30 to 600 (in
seconds).
renew-timer: Setting of the renew timer, in the range 120 to 2400 (in seconds).
threshold: Error packet ratio threshold, in the range 5 to 100 (in percentage).
Use the
error-diffusion restraint config
in error packet diffusion restraint.
Use the
undo error-diffusion restraint enable
default settings of the three parameters.
By default, the error packet detect timer is set to 30 seconds, the renew timer is
set to 600 seconds, and the error packet ratio threshold is 20.
The setting of renew timer must be at least four times that of the error packet
detect timer. If the total number of the packets received during detect-timer is less
than 100, error packets are not counted.
C
OMMANDS
Description
Line code, which can be AMI or HDB3.
Idle code, which can be 0x7E or 0xFF.
Iterframe filling tag, which can be 0x7E or 0xFF.
Number of interframe filling tags between two
successive frames.
Loopback state
Alarm state
Statistics on the interface
Indicates whether or not the counters are cleared
periodically
Statistics on the errors during the current interval
command to set the three parameters
command to restore the