Reverse-Rts; Timer Hold - H3C MSR 20-20 Command Reference Manual

Example

reverse-rts

Syntax
View
Parameter
Description
Example

timer hold

Syntax
View
Parameter
Description
# Set the MRU of interface serial 2/0 to 1,500 bytes (assuming that the interface is
an asynchronous serial interface and operates in flow mode).
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] physical-mode async
[Sysname-Serial2/0] async mode flow
[Sysname-Serial2/0] phy-mru 1500
reverse-rts
undo reverse-rts
Synchronous serial interface view
None
Use the command to reverse RTS signal for debugging purpose.
reverse-rts
Use the
undo reverse-rts
By default, RTS signal reverse is disabled.
This command is used in hardware flow control where the remote is not allowed
to send data when the local end is doing that.
# Reverse RTS signal.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] reverse-rts
timer hold seconds
undo timer hold
Serial interface view, AUX interface view, AM interface view, USB interface view
Seconds: Link state polling interval (in seconds) to be set, in the range 1 to 32,767.
Use the command to set the link state polling interval.
timer hold
Use the
undo timer hold
By default, the link state polling interval is 10 second.
command to restore the default.
command to restore the default.
199