Port-Group - H3C MSR 20-20 Command Reference Manual

Example

port-group

Syntax
View
Parameter
Description
Example
Use the
undo multicast-suppression
suppression ratio.
By default, all multicast traffic is allowed to go through an Ethernet interface, that
is, multicast traffic is not suppressed.
If you execute this command in Ethernet interface view, the configuration takes
effect only on the current interface. If you execute this command in port group
view, the configuration takes effect on all ports in the port group.
Note that when multicast traffic exceeds the maximum value configured, the
system will discard the extra packets so that the multicast traffic ratio can drop
below the limit to ensure that the network functions properly.
n
If you set different suppression ratios in Ethernet interface view or port group view
repeatedly, the last configuration takes effect.
# Set the maximum multicast traffic allowed on Ethernet 1/0 to 5952 PPS.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-GigabitEthernet1/0] multicast-suppression pps 5952
port-group { manual port-group-name | aggregation agg-id }
undo port-group manual port-group-name
System view
manual port-group-name: Specifies the name of a manual port group, a string of
1 to 32 characters.
aggregation agg-id: Specifies the ID of an existing port aggregation group. You
can use the display link-aggregation summary command to display the brief
information of all the existing port aggregation groups. The support for this
keyword-argument combination varies with device models.
Use the port-group manual
manual port group view.
Use the
port-group aggregation
Use the undo port-group manual
By default, no manual port group is created.
# Enter manual port group 1 view.
<Sysname> system-view
[Sysname] port-group manual group1
command to restore default multicast
command to create a manual port group and enter
command to enter aggregation group view.
command to remove a manual port group.
183