Alarm-Threshold - H3C MSR 20-20 Command Reference Manual

13

alarm-threshold

Syntax
View
Parameter
F
UNDAMENTAL
C
ONFIGURATION
alarm-threshold { ais { level-1 | level-2 } | lfa { level-1 | level-2 | level-3 | level-4 } |
los { pulse-detection | pulse-recovery } value }
undo alarm-threshold
CT1/PRI interface view
ais: Sets the alarm threshold of alarm indication signal (AIS), which can be level-1
and level-2.
The level-1 keyword specifies to generate an AIS alarm when the number of 0s
■
in the bit stream of an SF or ESF frame is less than or equal to 2.
The level-2 keyword specifies to generate an AIS alarm when the number of 0s
■
is less than or equal to 3 in the bit stream of an SF frame or less than or equal
to 5 in the bit stream of an ESP frame.
By default, level-1 AIS alarm threshold applies.
lfa: Sets the loss of frame align (LFA) alarm threshold, which can be level-1,
level-2, level-3, and level-4.
The level-1 keyword specifies to generate an LFA alarm when two of four
■
frame alignment bits are lost.
The level-2 keyword specifies to generate an LFA alarm when two of five
■
frame alignment bits are lost.
The level-3 keyword specifies to generate an LFA alarm when two of six frame
■
alignment bits are lost.
The level-4 keyword applies only to ESF frames. It specifies to generate an LFA
■
alarm when errors are detected in four consecutive ESF frames.
By default, level-1 LFA alarm threshold applies.
los: Sets a loss of signal (LOS) alarm threshold, which can be pulse-detection (for
the pulse detection duration threshold with LOS) and pulse-recovery (for the
pulse threshold with LOS).
The threshold of pulse-detection, in units of pulse intervals, ranges from 16 to
4,096 and defaults to 176.
The threshold of pulse-recovery, ranges from 1 to 256 and defaults to 22.
CT1/PRI I
NTERFACE
C
OMMANDS