Controller T1; Code (Ct1/Pri Interface View) - H3C MSR 20-20 Command Reference Manual

Example

code (CT1/PRI interface view)

Syntax
View
Parameter
Description
Example

controller t1

Syntax
View
Parameter
Description
Example
Use the command to restore the default clock source, that is, line
undo clock
clock.
When the CT1/PRI interface is working as DCE, choose the internal clock for it.
When it is working as DTE, choose the line clock for it.
# Use the internal clock as the clock source on CT1/PRI interface T1 2/0.
<Sysname> system-view
[Sysname] controller t1 2/0
[Sysname-T1 2/0] clock master
code { ami | b8zs }
undo code
CT1/PRI interface view
ami: Adopts AMI line code format.
b8zs: Adopts bipolar with 8-zero substitution (B8ZS) line code format.
Use the command to set the line code format for the CT1/PRI interface.
code
Use the undo code command to restore the default, that is, B8ZS.
Keep the line code format of the interface in consistency with the one used on the
remote device.
# Set the line code format of the interface T1 2/0 to AMI.
<Sysname> system-view
[Sysname] controller t1 2/0
[Sysname-T1 2/0] code ami
controller t1 number
System view
number: CT1/PRI interface number.
Use the
controller t1
# Enter the view of interface T1 2/0.
command to enter CT1/PRI interface view.
217