System Config > Dns; Figure 12 System Config > Routing Page Detail (Add Static Route); Figure 13 System Config > Dns Page Detail (Add Or Modify Name Servers); Add Or Modify Name Servers - Juniper MEDIA FLOW MANAGER 2.0.2 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

CHAPTER 3 Media Flow Manager Web-Based Interface
Figure 12 System Config > Routing Page Detail (Add Static Route)
System Config > DNS
View, add, modify, or remove Static and Dynamic Name Servers and Domain Names. See
for CLI details.
ip
Static and Dynamic Name Servers
View all configured static and dynamic name servers.
•
IP Address—Of the configured DNS server.
•
Active—Whether or not this DNS server is being used currently.
•
Source—"Configured" means it was manually added; "Dynamic" means it came from a
name server.

Add or Modify Name Servers

On the System Config > DNS page, you can set up to three Dynamic Name Servers (DNS).
See Figure 13
•
Primary DNS IP address—This DNS server is tried first.
•
Secondary DNS IP address—This DNS server is tried second.
•
Tertiary DNS IP address—This DNS server is tried last.
Click Apply to immediately apply changes; Cancel to revert to existing configuration.
Click Save at the top of the page to make changes persistent.
Figure 13 System Config > DNS Page Detail (Add or Modify Name Servers)
42 System Config
for graphic.
Media Flow Manager Administrator's Guide
Copyright © 2010, Juniper Networks, Inc.