Removing An Overriding Profile Assignment From An Atm Pvc - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Software for e series broadband services routers link layer configuration guide
Table of Contents

Advertisement

Copyright © 2010, Juniper Networks, Inc.
NOTE: You can reverse the order of Step 3 and Step 4 with identical results.
That is, you can assign the overriding profile to the ATM PVC and then
assign the base profile to the entire VC range. In either case, you must first
create the bulk-configured VC range with the atm bulk-config command.
Configure the ATM AAL5 interface to enable all bulk configurations and to support
6.
autodetection of the ATM 1483 dynamic encapsulation type.
host1(config-if)#auto-configure atm1483
(Optional) Use the show atm bulk-config command to verify the overriding profile
7.
configuration.
For more information about using this command, see "show atm bulk-config" on
page 683.

Removing an Overriding Profile Assignment from an ATM PVC

After you troubleshoot the ATM 1483 dynamic subinterface column created on the
specified PVC, make sure that you remove the overriding profile assignment to restore
the original base profile assignment. This action ensures that subsequent ATM 1483
dynamic subinterface columns are created using the same attributes defined in the base
profile.
To remove an overriding profile assignment from an ATM PVC within a bulk-configured
VC range:
Remove the overriding profile assignment from the specified ATM PVC.
1.
host1(config-if)#no profile atm1483 bulk-config-name myBulkConfig pvc 0 101
Select the dynamic ATM 1483 subinterface on which the ATM 1483 dynamic
2.
subinterface column resides.
host1(config)#interface atm 4/0.101
Use the shutdown command to disable the dynamic ATM 1483 subinterface. The
3.
shutdown command deletes the ATM 1483 dynamic subinterface column and removes
the dynamic ATM 1483 subinterface.
host1(config-subif)#shutdown
Send traffic over the specified PVC (VPI 0 and VCI 101) on the ATM AAL5 interface.
4.
This action re-creates the ATM 1483 dynamic subinterface column with the original
base profile association.
The router now uses the information in the base profile instead of the information in
the overriding profile to create subsequent ATM 1483 dynamic subinterface columns
for the specified PVC.
(Optional) Use the show atm bulk-config command to verify the removal of the
5.
overriding profile assignment.
For more information about using this command, see "show atm bulk-config" on
page 683.
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
643

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 and is the answer not in the manual?

This manual is also suitable for:

Junose 11.3

Table of Contents