Atm Bulk-Config - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

atm bulk-config

atm bulk-config bulkConfigName [ vc-range vpiStart vpiEnd vciStart vciEnd ]*
Syntax
no atm bulk-config bulkConfigName [ vc-range vpiStart vpiEnd vciStart vciEnd ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Configures a range of ATM PVCs for use by a dynamic ATM 1483 subinterface, and
Description
assigns a name to the virtual circuit (VC) range. Each VC range consists of one or
more nonoverlapping VC subranges. A VC subrange is a group of VCs that resides
within the specified VPI and VCI ranges. You can configure multiple VC ranges on
an ATM AAL5 interface. The no version removes the specified VC range (including
all subranges in the range) from the ATM AAL5 interface or the specified subrange
from the VC range. The no version also removes any overriding profile assignments
for ATM PVCs within the deleted VC range or VC subrange.
NOTE: The total number of VCs configured with the atm bulk-config command
cannot exceed the maximum ATM VC capacity of the line module you are using. For
details about the ATM VC capacity of supported line modules, see JUNOSe Release
Notes, Appendix A, System Maximums.
Options
Interface Configuration
Mode
bulkConfigName Name of the VC range; string of up to 80 characters
vpiStart Starting virtual path identifier (inclusive) of the VC subrange you are
configuring
vpiEnd Ending virtual path identifier (inclusive) of the VC subrange you are
configuring
vciStart Starting virtual circuit identifier (inclusive) of the VC subrange you are
configuring
vciEnd Ending virtual circuit identifier (inclusive) of the VC subrange you are
configuring
* Indicates that one or more parameters can be repeated multiple times in a
list in the command line
Chapter 2: A Commands
161
atm bulk-config