Removing An Overriding Profile Assignment From An Atm Pvc; Removing Overriding Profile Assignments From A Vc Range Or Vc Subrange - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide

Removing an Overriding Profile Assignment from an ATM PVC

After you troubleshoot the ATM 1483 dynamic subinterface column created on the
specified PVC, make sure that you remove the overriding profile assignment to restore
the original base profile assignment. This action ensures that subsequent ATM 1483
dynamic subinterface columns are created using the same attributes defined in the
base profile.
To remove an overriding profile assignment from an ATM PVC within a
bulk-configured VC range:
1.
2.
3.
4.
5.

Removing Overriding Profile Assignments from a VC Range or VC Subrange

When you issue the no atm bulk-config command to remove an entire VC range
(and all VC subranges within that VC range), the router also removes any overriding
profile assignments configured for PVCs within those VC subranges. For example,
the following command removes the bulk-configured VC range named myBulkConfig
and any overriding profile assignments for PVCs within the VC subranges belonging
to myBulkConfig.
648
Configuring ATM 1483 Dynamic Subinterfaces
For more information about using this command, see "show atm bulk-config"
on page 690.
Remove the overriding profile assignment from the specified ATM PVC.
host1(config-if)#no profile atm1483 bulk-config-name myBulkConfig pvc 0 101
Select the dynamic ATM 1483 subinterface on which the ATM 1483 dynamic
subinterface column resides.
host1(config)#interface atm 4/0.101
Use the shutdown command to disable the dynamic ATM 1483 subinterface.
The shutdown command deletes the ATM 1483 dynamic subinterface column
and removes the dynamic ATM 1483 subinterface.
host1(config-subif)#shutdown
Send traffic over the specified PVC (VPI 0 and VCI 101) on the ATM AAL5
interface. This action re-creates the ATM 1483 dynamic subinterface column
with the original base profile association.
The router now uses the information in the base profile instead of the information
in the overriding profile to create subsequent ATM 1483 dynamic subinterface
columns for the specified PVC.
(Optional) Use the show atm bulk-config command to verify the removal of the
overriding profile assignment.
For more information about using this command, see "show atm bulk-config"
on page 690.
host1(config-if)#no atm bulk-config myBulkConfig