Atm Bulk-Config - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

atm bulk-config

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
atm bulk-config bulkConfigName [ vc-range vpiStart vpiEnd vciStart vciEnd ]*
no atm bulk-config bulkConfigName [ vc-range vpiStart vpiEnd vciStart vciEnd ]
Command introduced before JunosE Release 7.1.0.
Configures a range of ATM PVCs for use by a dynamic ATM 1483 subinterface, and assigns
a name to the virtual circuit (VC) range. Each VC range consists of one or more
nonoverlapping VC subranges. A VC subrange is a group of VCs that resides within the
specified VPI and VCI ranges. You can configure multiple VC ranges on an ATM AAL5
interface. The no version removes the specified VC range (including all subranges in the
range) from the ATM AAL5 interface or the specified subrange from the VC range. The
no version also removes any overriding profile assignments for ATM PVCs within the
deleted VC range or VC subrange.
NOTE: The total number of VCs configured with the atm bulk-config
command cannot exceed the maximum ATM VC capacity of the line module
you are using. For details about the ATM VC capacity of supported line
modules, see JunosE Release Notes, Appendix A, System Maximums.
bulkConfigName—Name of the VC range; string of up to 80 characters
vpiStart—Starting virtual path identifier (inclusive) of the VC subrange you are
configuring
vpiEnd—Ending virtual path identifier (inclusive) of the VC subrange you are configuring
vciStart—Starting virtual circuit identifier (inclusive) of the VC subrange you are
configuring
vciEnd—Ending virtual circuit identifier (inclusive) of the VC subrange you are configuring
*—Indicates that one or more parameters can be repeated multiple times in a list in
the command line
Interface Configuration
Chapter 2: A Commands
159