Policy Condition Source Udp Port - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

QoS Policy Commands

policy condition source udp port

Configures a source UDP port number for a policy condition.
policy condition condition_name source udp port port[-port]
policy condition condition_name no source udp port
Syntax Definitions
condition_name
port
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of the command to remove a source UDP port from a condition; however, at least one
classification parameter must be associated with a condition.
•
This command is a shortcut for the
protocol also be specified. Rather than specifying source ip port and ip protocol, use source udp
port.
•
The same condition cannot specify a source UDP port with a service or service group.
•
IP port protocol types cannot be mixed in the same condition; ports must be either TCP or UDP.
•
Use this condition in combination with the IPv6 condition (policy condition ipv6) to configure IPv6
policies for Layer 4 information, services, and service groups.
Examples
-> policy condition cond5 source udp port 1200-1400
-> policy condition cond6 ipv6 source udp port 1000
-> policy condition cond5 no source udp port
Release History
Release 6.1; command was introduced.
Release 6.3.1; support for IPv6 policies added.
OmniSwitch CLI Reference Guide
The name of the condition.
The UDP port number of the source address of the Layer 3 flow, in the
range from 0–65535. A range of ports (separated by a hyphen) may be
specified instead of a single port.
policy condition source ip port
June 2012
command, which requires that the
page 33-71