General Procedures; Mounting Instructions For Sealings - ABB CRB 15000 Product Manual

5 Repair

5.2.1 Mounting instructions for sealings

5.2 General procedures

5.2.1 Mounting instructions for sealings
General
This section describes how to mount different types of sealings.
Equipment
Consumable
Grease
Rotating sealings
The following procedures describe how to fit rotating sealings.
Radial sealings
A radial sealing consists of a flexible rubber lip bonded to a rigid metal case. Only
one side of the sealing is static with a metal insert.
xx2300000433
1
Continues on next page
202
CAUTION
Please observe the following before commencing any assembly of sealings:
• Protect the sealing during transport and mounting, especially the main lip
on radial sealings.
• Keep the sealing in its original wrappings or protect it well before actual
mounting.
• The fitting of sealings and gears must be carried out on clean workbenches.
• Use a protective sleeve for the main lip during mounting, when sliding over
threads, keyways or other sharp edges.
Action
Check the sealing to ensure that:
• The sealing is of the correct type.
• There is no damage on the main lip.
© Copyright 2021 - 2023 ABB. All rights reserved.
Article number Note
3HAC042536-001 Shell Gadus S2
Note
Product manual - CRB 15000
3HAC077389-001 Revision: L