ABB CRB 15000 Product Manual page 984

5 Repair
5.6.7 Replacing the axis-5 joint unit and the axis-5 to axis-6 transition cabling
Continued
2
Removing the axis-4 cover
1
2
3
Continues on next page
984
Action
Valid for CRB 15000-10/1.52 and CRB 15000-
12/1.27
Remove the covers by removing the screws.
Action
Remove the cover screws.
CAUTION
Valid for CRB 15000-5/0.95
There is cabling connected between the cover
and the joint unit drive board.
Open the cover with care to avoid damage to the
cabling or the connector(s).
Do not leave the cover in location without being
secured with the attachment screws.
For robots with RobotWare earlier than 7.10
Open the cover and cut the cable tie that holds
the brake release cable.
© Copyright 2021 - 2023 ABB. All rights reserved.
Note
xx2300000841
Note
xx2000002083
xx2000002084
Product manual - CRB 15000
3HAC077389-001 Revision: L