ABB CRB 15000 Product Manual page 379

Spare part
Cable harness, joint 4
Cable harness, joint 4
Cable tie
Required tools and equipment
Equipment
Lifting aid
Guide pin, M3x110
Tweezers
Protection plate
Cable tie gun EVO 7i
Standard toolkit
Required consumables
Consumable
Cable ties
O-ring
O-ring
Gasket
O-ring
O-ring
Product manual - CRB 15000
3HAC077389-001 Revision: L
Article number
3HAC073206-001
3HAC080961-001
3HAC075545-001
Article number
3HAC077789-001
3HAC077787-001
-
3HAC077790-001
-
-
Article number
-
3HAC061327-051
3HAC061327-051
3HAC075056-001
3HAC061327-047
3HAC061327-047
© Copyright 2021 - 2023 ABB. All rights reserved.
5.3.5 Replacing the axis-4 cabling
Note
Used for CRB 15000-5/0.95.
Also order new Cable tie:
3HAC075545-001.
Used for CRB 15000-10/1.52 and
CRB 15000-12/1.27.
Also order new Cable tie:
3HAC075545-001.
For securing joint unit cable.
Note
For joint units on axes 4, 5 and 6.
Attachment screws M3x12 (4 pcs)
are enclosed.
Always use guide pins in pairs.
For joint units on axes 4, 5 and 6.
Used to handle drive board con-
nectors.
For protection of drive board
during cabling installation on joint
units of CRB 15000-5/0.95.
HellermannTyton 110-77001 or
similar
Content is defined in section
Standard toolkit on page
Note
Axis-4 cover, used for CRB
15000-5/0.95.
Replace if damaged.
Axis-4 cover, used for CRB
15000-10/1.52 and CRB 15000-
12/1.27.
Replace if damaged.
Cover inside housing
Replace if damaged.
Cover for axis 2/3, used for CRB
15000-5/0.95.
Replace if damaged.
Housing cover, used for CRB
15000-10/1.52 and CRB 15000-
12/1.27.
Replace if damaged.
Continues on next page
5 Repair
Continued
1087.
379