6
7
Disconnecting the axis-4 joint unit cabling
1
Product manual - CRB 15000
3HAC077389-001 Revision: L
Action
Disconnect the connectors that belongs to the
axis-5 cabling, from the axis-4 drive board:
•
D3/4.X2
•
D3/4.DC-
•
D3/4.DC+
Use tweezers, if needed.
Pull out the cabling carefully from the tubular.
Action
Disconnect the connectors from the drive board.
CAUTION
Use tweezers to unlock connectors and pull them
off.
•
D4/5.X1
•
D4/5.X4
•
D4/5.X5
© Copyright 2021 - 2023 ABB. All rights reserved.
5.6.6 Replacing the axis-4 joint unit
Note
Tweezers
xx2000002125
Valid for CRB 15000-5/0.95
xx2000002126
Valid for CRB 15000-10/1.52 and
CRB 15000-12/1.27
xx2300000844
Note
Tweezers
xx2000002088
Continues on next page
5 Repair
Continued
955