ABB CRB 15000 Product Manual page 820

5 Repair
5.6.2 Replacing the axis-1 joint unit (CRB 15000-10/1.52 and CRB 15000-12/1.27)
Continued
3
4
Continues on next page
820
Action
Remove the swing attachment screws.
CAUTION
Do not mix the flange screws used for CRB 15000-
5/0.95 and the threaded screws used for CRB
15000-10/1.52 and CRB 15000-12/1.27. Always
use washers together with the threaded screws
for CRB 15000-10/1.52 and CRB 15000-12/1.27.
Illustration is for reference only.
Use two fully threaded attachment screws as re-
moval tools to press the swing out of position.
CAUTION
Do not mix the flange screws used for CRB 15000-
5/0.95 and the threaded screws used for CRB
15000-10/1.52 and CRB 15000-12/1.27. Always
use washers together with the threaded screws
for CRB 15000-10/1.52 and CRB 15000-12/1.27.
Illustration is for reference only.
© Copyright 2021 - 2023 ABB. All rights reserved.
Note
Valid for CRB 15000-10/1.52
xx2300000819
Valid for CRB 15000-12/1.27
xx2000001987
Valid for CRB 15000-10/1.52
xx2300000822
Valid for CRB 15000-12/1.27
xx2000002152
Product manual - CRB 15000
3HAC077389-001 Revision: L