ABB CRB 15000 Product Manual page 222

5 Repair
5.3.2 Replacing the axis-1 cabling
Continued
Spare part
Cable harness, joint 1
Cable harness, joint 1 (CRB 15000-
10/1.52)
Cable harness, joint 1 (CRB 15000-
12/1.27)
Flange socket head screw with
glue
Cable tie
Required tools and equipment
Equipment
Lifting aid
Lifting aid
Guide pin, M4x120
Guide pin, M5x150
Protection plate
Protection plate
Cable tie gun EVO 7i
Continues on next page
222
Article number
3HAC073204-001
3HAC083661-001
3HAC080959-001
3HAB3413-435
3HAC075545-001
Article number
3HAC077788-001
3HAC087787-001
3HAC077786-001
3HAC087786-001
3HAC077790-001
3HAC087789-001
-
© Copyright 2021 - 2023 ABB. All rights reserved.
Note
Used for CRB 15000-5/0.95.
Also order new Cable tie:
3HAC075545-001.
Used for CRB 15000-10/1.52.
Also order new Cable tie:
3HAC075545-001.
Used for CRB 15000-12/1.27.
Also order new Cable tie:
3HAC075545-001.
M4x35 12.9 Lafre
2C2B/FC6.9+PrO-COat111, with
NYPLAS glue , 12 pcs
Used for joint unit of CRB 15000-
5/0.95.
Always use new screws when re-
fitting a joint unit. If ordering a
new joint unit spare part, new
screws are included.
For securing joint unit cable.
Note
For joint units on axes 1, 2 and 3
of CRB 15000-5/0.95.
Attachment screws M4x35 (4 pcs)
are enclosed.
For joint units on axes 1 and 2 of
CRB 15000-10/1.52 and CRB
15000-12/1.27.
A plate, a beam, a pair of semicir-
cular blocks and attachment
screws M5x30 (2 pcs) are en-
closed.
Always use guide pins in pairs.
For joint units on axes 1, 2 and 3
of CRB 15000-5/0.95 and axis 3
of CRB 15000-10/1.52 and CRB
15000-12/1.27.
Always use guide pins in pairs.
For joint units on axes 1 and 2 of
CRB 15000-10/1.52 and CRB
15000-12/1.27.
For protection of drive board
during cabling installation on joint
units of CRB 15000-5/0.95.
For protection of drive board
during cabling installation on joint
units of CRB 15000-10/1.52 and
CRB 15000-12/1.27.
HellermannTyton 110-77001 or
similar
Product manual - CRB 15000
3HAC077389-001 Revision: L