Show Port Trap - Avaya G250 Reference

show port trap

Use the show port trap command to display information on SNMP generic link up/down
traps sent for a specific port. If no port is specified, information for all ports is displayed.
Syntax
show port trap [module[/port]]
Parameters
Parameter
module
port
User level
read-only
Context
general
Example
To display trap information for port 1 of module 4:
G350-001(super)# show port trap 4/1
Port 4/1 up/down trap is disabled
Related commands - SNMP access configuration
ip snmp-server,
snmp engineID,
show snmp user
snmp-server engineID,
snmp-server view
Related commands - SNMP trap configuration
clear snmp trap,
enable notifications,
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 4/5-13 for
ports 5 to 13 on module 4.
set snmp community,
show snmp group, show snmp
summary, show snmp
snmp-server group,
set port trap, set snmp
snmp-server host,
set snmp retries, set snmp
retries, show snmp
usertogroup, show snmp
snmp-server remote-user,
trap, show snmp, snmp trap
snmp-server informs
Alphabetical listing of CLI commands
Possible Default
Values Value
timeout, show snmp,
timeout, show snmp
view, snmp-server
snmp-server
link-status, snmp-server
Issue 1.1 June 2005
show
user,
community,
user,
673