set contact-closure admin
Use the set contact-closure admin command to specify how the contact closure relay is
controlled.
Note:
The set contact-closure pulse-duration command does not affect the
Note:
set contact-closure admin manual command.
Syntax
set contact-closure admin module/port:relay
{mgc | manual-trigger | manual-off}
Parameters
Parameter
module
port
relay
mgc
manual-trigger
manual-off
User level
read-write
Context
general
Example
To specify that contact closure for relay 2 of port 1 on module 10 is controlled by the call
controller:
G350-001(super)# set contact-closure admin 10/1:2 mgc
Related commands
set contact-closure
Description
Module number of the contact closure port
Port number of the contact closure port
Contact closure relay
Contact closure is controlled by the call
controller
Contact closure relay is triggered
Contact closure relay is not triggered
pulse-duration,
show contact-closure
Alphabetical listing of CLI commands
Possible
Values
10
1
1, 2
Issue 1.1 June 2005
Default
Value
395