Interface Loopback - Avaya G250 Reference

CLI Commands

interface Loopback

Use the interface Loopback command to enter Interface Loopback configuration mode.
Use the no form of this command to delete a loopback interface or sub-interface.
If the specified interface does not exist, the system creates it and enters its configuration mode.
Syntax
[no] interface Loopback [interface_number[.ip_interface]]
Parameters
Parameter
interface_number
ip_interface
User level
read-write
Context
general
Example
To create Loopback interface 1 and enter its configuration mode:
G350-001(super)# interface Loopback 1
To create a Layer 3 sub-interface:
G350-001(super)# interface Loopback 1.1
To delete the Layer 3 sub-interface:
G350-001(super)# no interface Loopback 1.0
Related commands
description (interface),
tunnel, interface
load-interval, show ip interface brief
214 Avaya G250 and Avaya G350 CLI Reference
Description
The number of the interface
The IP sub-interface number within this
interface. A number of IP interfaces may be
bound to a Layer 3 interface.
interface Console,
usb, interface vlan, ip
interface FastEthernet,
address, ip admin-state,
Possible
Values
1-99
0-1024
interface serial, interface
ip broadcast-address,
Default
Value