Show Ip Reverse-Arp - Avaya G250 Reference

Example
To display information about all QoS lists:
G350-001(if:Vlan 1)# show ip qos-list all
List Number: 400
---------------
List Name: Default QoS List
Default Action: No-Change
Owner: other
List Trust: trust-cos
To display detailed information about all the QoS lists on all the interfaces:
G350-001(super)# show ip qos-list all detailed
Index Name
----- ------------------------------- --------------------------
400 Default QoS List
Index Protocol
----- -------- --- ---------------- --------------- --------------
Deflt Any
Dst Any
Index Name
----- ------------------------------- --------------------------
440 list #440
Index Protocol
----- -------- --- ---------------- --------------- ------- ----------
Deflt Any
Dst Any
Related commands
ip access-control-list,
pre-classification,
queue-limit, set qos
voip-queue-delay

show ip reverse-arp

Use the show ip reverse-arp command to display the IP address of a host, based on a
known MAC address.
Syntax
show ip reverse-arp mac_addr [match_len]
IP
Src Any
IP
Src Any AnyTrust-DSCP-CoS
ip access-group, ip
show ip access-control-list,
bearer, set qos control,
Alphabetical listing of CLI commands
Owner
other
Wildcard
Any
Owner
other
Wildcard
Any
policy-list-copy, ip qos-group,
interface FastEthernet,
set qos signal, show
Port Operation
Any Trust-DSCP-CoS
PortOperation
ip qos-list, ip simulate,
interface serial,
queue, show voip-parameters,
Issue 1.1 June 2005 613