Pppoe-Client Wait-For-Ipcp - Avaya G250 Reference

CLI Commands
Example
G350-001(super-if:FastEthernet 10/2)# pppoe-client service-name isp1
Related commands
encapsulation
pppoe-client persistent
show ppp authentication

pppoe-client wait-for-ipcp

Use the pppoe-client wait-for-ipcp command to configure the amount of time
between PPPoE tunnel establishment and IPCP tunnel establishment. The PPPoE client
terminates the PPPoE tunnel if this time is exceeded.
Note:
The PPP stack has a somewhat similar command: ppp timeout ncp.
Note:
However while this command only terminates the LCP, the pppoe-client
wait-for-ipcp command terminates the PPPoE tunnel.
Syntax
pppoe-client wait-for-ipcp seconds
no pppoe-client wait-for-ipcp seconds
Parameters
Parameter
seconds
User level
Read-write
Context
Interface: Fast Ethernet
Example
G350-001(super-if:FastEthernet 10/2)# pppoe-client wait-for-ipcp 30
356 Avaya G250 and Avaya G350 CLI Reference
pppoe, mtu, ppp chap
delay, pppoe-client persistent
Description
The number of seconds to wait
hostname, ppp chap password,
max-attempts,
ppp pap-sent username,
pppoe-client wait-for-ipcp,
Possible Default
Values Value
5-10000 20