ip address dhcp
Use the ip address dhcp command to enable IP address negotiation via DHCP. Use the no
form of this command to disable IP address negotiation via DHCP.
Note:
The ip address dhcp command can only be used on FastEthernet 10/2.
Note:
Note:
You cannot configure both ip address dhcp and keepalive-track (object
Note:
tracking) on the WAN Fast Ethernet interface.
You cannot configure both ip address dhcp and keepalive-icmp
(extended keepalive) on the WAN Fast Ethernet interface.
You cannot configure both ip address dhcp and ip address negotiated
(PPP/IPCP address negotiation) on the WAN Fast Ethernet interface.
Note:
You can run ip address dhcp as many times as desired to re-initiate DHCP
Note:
address negotiation. Whenever you change the value of a DHCP client
parameter (such as client-id, client hostname), run ip address dhcp again to
re-initiate DHCP address negotiation using the new values.
Syntax
[no] ip address dhcp
User level
read-write
Context
Interface: Fast Ethernet
Example
G350-001(config-if:FastEthernet 10/2)#ip address dhcp
Related commands
clear ip dhcp-client
lease,
ip dhcp client
dhcp-client statistics
statistics,
ip dhcp client
request,
release
dhcp,
Alphabetical listing of CLI commands
client-id,
ip dhcp client
renew
dhcp,
show ip
hostname,
ip dhcp client
dhcp-client,
show ip
Issue 1.1 June 2005
223