Show Port Edge State - Avaya G250 Reference

CLI Commands

show port edge state

Use the show port edge state command to display the edge state of the specified port. If
no port is specified, information for all ports is displayed.
Note:
This command is not supported by the G250.
Note:
Syntax
show port edge state [module/[port]]
Parameters
Parameter
module
port
User level
read-only
Context
general
Example
To show edge state for all ports:
G350-001(super)# show port edge state
Related commands
set port auto-negotiation-flowcontrol-advertisement,
edge admin state,
negotiation, set port point-to-point admin
auto-negotiation-flowcontrol-advertisement,
664 Avaya G250 and Avaya G350 CLI Reference
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 4/5-13 for
ports 5 to 13 on module 4.
set port enable, set port
set port disable,
flowcontrol, set port
status, set port speed,
show port flowcontrol
Possible Default
Values Value
set port duplex,
level, set port name, set port
show port
set port