Ip Ospf Dead-Interval - Avaya G250 Reference

CLI Commands

ip ospf dead-interval

Use the ip ospf dead-interval command to configure the interval before declaring the
neighbor as dead. Use the no form of this command to set the dead-interval to its default value.
Syntax
ip ospf dead-interval seconds
no ip ospf dead-interval
Parameters
Parameter
seconds
User level
read-write
Context
Interface: Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3), VLAN (L2-L3, L3), Loopback (L2-L3,
L3), Tunnel (L3, L2-L3)
Example
To specify an interval of 15 seconds to wait before declaring a neighbor dead:
G350-001(if:Vlan 1)# ip ospf dead-interval 15
Related commands
ip ospf authentication,
message-digest-key,
ospf, show ip ospf,
ip protocols
260 Avaya G250 and Avaya G350 CLI Reference
Description
The interval in seconds
ip ospf authentication-key,
ip ospf network point-to-multipoint,
show ip ospf database,
ip ospf cost, ip ospf
ip ospf priority,
show ip ospf interface,
Possible Default
Values Value
1-415029 40
hello-interval, ip ospf
ip ospf router-id,
show ip ospf neighbor,
router
show