Set Port Duplex - Avaya G250 Reference

CLI Commands

set port duplex

Use the set port duplex command to configure the duplex type of an Ethernet or Fast
Ethernet port or range of ports. You can configure Ethernet and Fast Ethernet interfaces to
either full duplex or half duplex.
The duplex status of a port in auto-negotiation mode is determined by auto-negotiation. An error
message is generated if you try to set the transmission type of auto negotiation Fast Ethernet
ports to half-duplex or full-duplex mode.
Syntax
set port duplex module/port {full|half}
Parameters
Parameter
module
port
full
half
User level
read-write
Context
general
Example
To set port 1 on module 4 to full duplex:
G350-001(super)# set port duplex 4/1 full
Port 4/1 set to full-duplex.
Related commands
set port auto-negotiation-flowcontrol-advertisement,
set port enable,
point-to-point admin
auto-negotiation-flowcontrol-advertisement,
440 Avaya G250 and Avaya G350 CLI Reference
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 4/5-13 for
ports 5 to 13 on module 4.
Set full-duplex transmission
Set half-duplex transmission
set port flowcontrol, set port
status, set port speed,
set port disable,
level, set port name,
show port
show port edge state,
Possible Default
Values Value
set port edge admin
set port negotiation, set port
show port flowcontrol
state,