Example
G350-001(config-crypto:10)# set transform-set ts1
Related commands
continuous-channel,
peer-group,
show crypto map
set trunk
Use the set trunk command to configure the VLAN tagging mode of a port.
Syntax
set trunk module/port {off|dot1q}
Parameters
Parameter
module
port
off
dot1q
User level
read-write
Context
general
crypto
map,
description (crypto
Description
Number of the module
Number of the port on the module.
You can also specify a range of ports
separated by a dash, for example, 4/5-13 for
ports 5 to 13 on module 4 of the G350. To
specify ETH LAN ports 3-5 on the front
panel of the G250, use the syntax 10/3-5.
Keyword that specifies to force the port to
become a non-tagging port and persuade
the neighboring port to become a
non-tagging port. The port becomes a
non-tagging port even if the neighbor port
does not agree to become a non-tagging
port.
Keyword that specifies IEEE 802.1q tagging
on a Fast Ethernet or Gigabit Ethernet port
Alphabetical listing of CLI commands
map),
set
dscp,
set peer (crypto
Possible
Values
Issue 1.1 June 2005
map),
set
Default
Value
505