Ignore Dcd; Initiate Mode Aggressive - Avaya G250 Reference

CLI Commands

ignore dcd

Use the ignore dcd command to specify how the system monitors the line to determine if it is
up or down. Specify ignore dcd to ignore DCD signals, and instead use DSR/CTS signals to
determine the line's status. Use the no form of the command to specify that DCD signals are
used to determine line status.
Syntax
[no] ignore dcd
User level
read-write
Context
Interface: Serial (USP FR-L2, USP PPP-L2, USP PPP L2-L3)
Example
To ignore DCD signals on an interface:
G350-001(if:Serial 2/1:1)# ignore dcd
Related commands
bandwidth, idle-character,

initiate mode aggressive

Use the initiate mode aggressive command to instruct the device to work in IKE
aggressive mode. Use the no form of this command to restore the default setting, which is IKE
main mode.
Note:
Aggressive mode is one of the prerequisites for working with dynamic IP
Note:
addresses.
Syntax
[no] initiate mode aggressive
User level
read-write
210 Avaya G250 and Avaya G350 CLI Reference
interface serial, invert txclock, nrzi-encoding, transmitter-delay