Tcp Source-Port - Avaya G250 Reference

CLI Commands
Example
To specify that rule 27 applies only to packets from an established TCP session:
G350-001(ACL 330/ip rule 27)# tcp established
Rule protocol changed.
Related commands - Policy
composite-operation, destination-ip,
show composite-operation,
destination-port,

tcp source-port

Use the tcp source-port command to define a source port with the TCP protocol for which
to apply the current rule. Use the no form of the command to specify that the rule applies to all
ports other than the defined port.
Note:
Issuing this command also sets the protocol to be TCP, if it is not already.
Note:
Syntax
[no] tcp source-port any | {{eq | lt | gt} {port_name | port_number}}
| {range start_port end_port}
no tcp source-port
Parameters
Parameter
any
eq
lt
gt
764 Avaya G250 and Avaya G350 CLI Reference
dscp (policy, policy-based routing, packet
show ip-rule, source-ip,
udp source-port
Description
Keyword that specifies to apply the rule to a port
with any name or number
Keyword that specifies to apply the rule to a port
whose name or number matches exactly to the
specified name or number
Keyword that specifies to apply the rule to a port
whose name or number is less than the specified
name or number
Keyword that specifies to apply the rule to a port
whose name or number is greater than the
specified name or number
tcp destination-port, tcp
Possible
Values
sniffing), icmp,
source-port, udp
Default
Value