Udp Source-Port - Avaya G250 Reference

Parameter
start_port
end_port
User level
read-write
Context
ip pbr-list ip-rule, ip qos-list ip-rule, ip capture-list ip-rule, ip access-control-list ip-rule
Example
To specify that rule 22 applies to all packets whose destination port is 300:
G350-001(ACL 330/ip rule 22)# udp destination-port eq 300
Related commands - Policy-based routing
destination-ip, dscp (policy, policy-based routing, packet
capture-list, source-ip,
Related commands - Policy
composite-operation, destination-ip,
show composite-operation,
established, tcp

udp source-port

Use the udp source-port command to define a source port with the UDP protocol for which
to apply the current rule. Use the no form of the command to specify that the rule applies to all
ports other than the defined port.
Note:
Issuing this command also sets the protocol to be UDP, if it is not already.
Note:
Syntax
udp source-port any | {{eq | lt | gt} {port_name | port_number}}
| {range start_port end_port}
Description
The start of a port range for which to apply the
rule
The end of a port range for which to apply the
rule
tcp destination-port,
dscp (policy, policy-based routing, packet
show dscp-table,
source-port, udp source-port
Alphabetical listing of CLI commands
sniffing), icmp, ip-protocol,
tcp source-port, udp source-port
show ip-rule, source-ip,
Possible Default
Values Value
show ip
sniffing), icmp,
tcp destination-port, tcp
Issue 1.1 June 2005 791