CLI Commands
ip address
Use the ip address command to assign an IP address and mask to an interface. Use the no
form of this command to delete an IP interface.
Syntax
ip address {ip_address mask [admin_state]}|negotiated
no ip address
Parameters
Parameter
ip_address
mask
admin_state
negotiated
User level
read-write
Context
Interface: Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3), VLAN (L2-L3, L3), Console, USB,
Loopback (L2-L3, L3), Tunnel (L2-L3, L3), Dialer
Example
To assign the IP address 192.168.22.33 with mask 255.255.255.0 to the Fast Ethernet
interface:
G350-001(if:FastEthernet 10/2)# ip address 192.168.22.33 255.255.255.0
Related commands
description
(interface),
serial,
interface
load-interval,
show ip interface brief
222 Avaya G250 and Avaya G350 CLI Reference
Description
The IP address assigned to the interface
Mask for the associated IP subnet.
The administration status. This parameter is not
used with the Console interface.
Interface receives address and mask from a remote
device.
interface
Console,
tunnel,
interface
usb,
interface
FastEthernet,
interface
vlan,
ip
admin-state,
Possible
Default
Values
Value
up, down
up
interface
Loopback,
interface
ip
broadcast-address,