Ip Rip Send-Receive-Mode - Avaya G250 Reference

CLI Commands
Context
Interface: Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3), VLAN (L2-L3, L3), Loopback (L2-L3,
L3), Tunnel (L2-L3, L3)
Example
To specify that RIP version 2 packets should be running on the Serial 2/1:1 interface:
G350-001(if:Serial 2/1:1)# ip rip rip-version 2
Related commands
ip distribution access-list,
default-route-mode,
rip, show ip protocols

ip rip send-receive-mode

Use the ip rip send-receive-mode command to set the RIP send and receive modes on
an interface. Use the no form of this command to set the RIP to talk (that is, send report).
Syntax
ip rip send-receive-mode mode [default_route_metric]
no ip rip send-receive-mode
Parameters
Parameter
mode
default_
route_metric
276 Avaya G250 and Avaya G350 CLI Reference
ip rip authentication
ip rip poison-reverse,
Description
The RIP send and
receive mode
The route metric
index
key, ip rip authentication
ip rip send-receive-mode,
Possible Values
talk-listen — RIP receives
and transmits updates on the
interface.
talkdefault-listen — RIP
receives updates on the
interface and sends only a
default route.
listen-only — RIP receives
updates on the interface and
does not transmit them.
1-15
mode, ip rip
ip rip split-horizon, router
Default Value
talk-listen