User level
read-write
Context
Interface: Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3), VLAN (L2-L3, L3), Loopback (L2-L3,
L3), Tunnel (L2-L3, L3)
Example
To set the RIP protocol to receive and transmit update on the Serial interface:
G350-001(if:Serial 2/1:1)# ip rip send-receive-mode talk-listen
Related commands
ip distribution
access-list,
default-route-mode,
ip protocols
ip rip split-horizon
Use the ip rip split-horizon command to enable the split-horizon mechanism on the
current interface. Use the no form of this command to disable the split-horizon mechanism. By
default split-horizon is enabled.
The split-horizon mechanism prevents information about routes from exiting the router interface
through which the information was received. This prevents routing loops.
Syntax
[no] ip rip split-horizon
User level
read-write
Context
Interface: Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3), VLAN (L2-L3, L3), Loopback (L2-L3,
L3), Tunnel (L2-L3, L3)
Related commands
ip distribution
access-list,
default-route-mode,
show ip protocols
ip rip authentication
ip rip
poison-reverse,
ip rip authentication
ip rip
poison-reverse,
Alphabetical listing of CLI commands
key,
ip rip authentication
ip rip
rip-version,
ip rip
key,
ip rip authentication
ip rip
rip-version,
ip rip
mode,
ip rip
split-horizon,
router
rip,
mode,
ip rip
send-receive-mode,
router
Issue 1.1 June 2005
show
rip,
277