CLI Commands
test led
Use the test led command to run a test of the device's LED operation.
Syntax
test led
User level
read-only
Context
general
Example
To run a test of the device's LED operation:
G350-001(super)# test led
The Box level ALM, CPU and MDM LEDs should be BLINKING for 5 seconds each.
Related commands
set utilization
cpu,
recovery,
show
utilization,
show voltages
test voip-dsp
Use the test voip-dsp command to start a BTR test on the VoIP engine. Also refer to:
busyout voip-dsp
Note:
If you do not run the busyout voip-dsp command before the test
Note:
voip-dsp command, only non-disruptive tests will run.
Note:
Status changes during the test create SNMP traps.
Note:
Note:
To view the results of the most recent BTR test, refer to
Note:
770 Avaya G250 and Avaya G350 CLI Reference
show
faults,
show mg
restart-log,
show
status,
on page 53, and
release voip-dsp
list_config,
show
mgc,
show
system,
show
temp,
on page 364.
show
mm,
show
module,
show
timeout,
show
show mm
on page 653.
show