Set Qos Control - Avaya G250 Reference

set qos control

Use the set qos control command to define the source for QoS control parameters. The
source can be either local where the user configures the values via the CLI, or remote in which
case the values are obtained from the Media Gateway Controller. The default value is remote.
Syntax
set qos control {local | remote}
Parameters
Parameter
local
remote
User level
read-write
Context
general
Example
To specify that QoS values are configured locally via the CLI:
G350-001(super)# set qos control local
Related commands
interface FastEthernet,
signal, show ip
Description
Keyword that specifies to configure QoS
values via the CLI
Keyword that specifies to obtain QoS values
from the media gateway controller
interface serial, queue-limit,
qos-list, show queue,
set qos
show voip-parameters,
Alphabetical listing of CLI commands
Possible Default
Values Value
bearer, set qos control,
voip-queue-delay
Issue 1.1 June 2005
set qos
473