Testing Port Network Equipment; Checking Pn Status For Each Media Gateway; Checking Circuit Pack Configuration - Avaya G650 Installing

Testing the complete configuration

Testing port network equipment

The tests in this section verify that the TDM cables and terminators work. If you see a FAIL
result code, check these cables. If problems persist, see the maintenance book for your
configuration.

Checking PN status for each media gateway

The PN status can suggest problem areas. Tests that are described later in this section provide
more specific diagnostic information.
To check the PN status for each media gateway:
1. Type status port-network number <1-64> and press Enter.
2. Verify these service states:

Checking circuit pack configuration

The list configuration report provides a list of circuit packs that are connected to the
configuration and recognized by the software.
To check circuit pack configuration:
1. Type list configuration all and press Enter.
2. Ensure that the software is communicating with each circuit pack, except the power supply
circuit packs. Do not attempt to correct any problems until later, after you run the diagnostic
tests.
58 Installing the Avaya G650 Media Gateway
Field Service State
TDM Bus A in
TDM Bus B in
Tone/Clock in
PKT in