tunnel source
Use the tunnel source command to specify the IP address of the source interface for the
GRE tunnel. The source interface is the interface used to direct all traffic into the tunnel.
Note:
The CLI does not verify that the specified IP address actually exists.
Note:
Syntax
tunnel source ip-address
Parameters
Parameter
ip-address
User level
read-write
Context
Interface: Tunnel (L2, L2-L3)
Example
G350-001(super)# tunnel source 90.0.0.10
Related commands
keepalive (GRE
path-mtu-discovery,
Description
The IP address of the source interface for
the GRE tunnel
tunnel),
tunnel
checksum,
tunnel ttl
Alphabetical listing of CLI commands
tunnel
destination,
tunnel
Possible
Default
Values
Value
key,
tunnel
Issue 1.1 June 2005
787