Set Port Flowcontrol - Avaya G250 Reference

set port flowcontrol

Use the set port flowcontrol command to set the send/receive mode for flow-control
frames (IEEE 802.3x or proprietary) for a full duplex port. Each direction (send or receive) can
be configured separately.
Syntax
set port flowcontrol {receive | send | all} module/port {off | on |
proprietary}
Parameters
Parameter
receive
send
all
module
port
off
Description
Indicates whether the port can receive its
administrative status from a remote
device.
This option is only available for Gigabit
Ethernet modules with negotiation set to
off.
Indicates whether the local port can send
its administrative status to a remote
device.
This option is only available for Gigabit
Ethernet modules with negotiation set to
off.
Send and receive (symmetric flow control)
Used with on indicates that the local port
acts upon and sends flow control frames.
Used with off indicates that the local port
discards and does not send flow control
frames.
Number of the module
Number of the port on the module
Used with receive to turn off an attached
device's ability to send flow-control
packets to a local port. Used with send to
turn off the local port's ability to send
administrative status to a remote device.
Alphabetical listing of CLI commands
Possible Default
Values Value
Issue 1.1 June 2005 443