Set Port Spantree Cost - Avaya G250 Reference

Example
To enable spanning tree on port 1 of module 3:
P480-1# set port spantree enable 3/1
port 3/1 was enabled on spantree
Related commands
set port spantree
spantree default-path-cost,
spantree hello-time,
spantree version,

set port spantree cost

Use the set port spantree cost command to set the spanning tree cost of a port. This
value defines which port will be allowed to forward traffic if two ports with different costs cause a
loop.
Note:
This command is not supported by the G250.
Note:
Syntax
set port spantree cost [module/port] [value]
Parameters
Parameter
module
port
value
User level
read-write
Context
general
cost, set port spantree
set spantree
set spantree max-age,
show spantree
Description
The module number
The port number
Number representing the cost. A lower
value specifies precedence of a port to
forward traffic.
Alphabetical listing of CLI commands
force-protocol-migration,
enable/disable, set spantree
set spantree priority,
set port spantree priority,
forward-delay, set
set spantree tx-hold-count,
Possible Default
Values Value
1-65535
Issue 1.1 June 2005
set
set
461