Show Port Lldp Config - Avaya G250 Reference

CLI Commands
Related commands
set port auto-negotiation-flowcontrol-advertisement,
edge admin state,
negotiation, set port point-to-point admin
auto-negotiation-flowcontrol-advertisement,
Output fields
Field
Port
Send-
Flowcontrol-Admin
Send-
Flowcontrol-Oper
Receive-Flowcontrol-
Admin
Receive-Flowcontrol-
Oper

show port lldp config

Use the show port lldp config command to display port-level LLDP configuration.
Syntax:
show port lldp config [module/port]
666 Avaya G250 and Avaya G350 CLI Reference
set port enable, set port
Description
Module and port number
Send flow-control administration. Possible settings:
ON — indicates that the local port is allowed to send flow
control frames to the far end.
OFF — indicates that the local port is not allowed to send flow
control frames to the far end.
Send flow-control operation mode. Possible modes:
ON — indicates that the local port will send flow control frames
to the far end.
OFF — indicates that the local port will not send flow control
frames to the far end.
Receive flow-control administration. Possible settings:
ON — indicates that the local port will act upon flow control
indications if received from the far end.
OFF — indicates that the local port will discard flow control
frames if received from the far end.
Receive flow-control operation mode. Possible modes:
ON — indicates that the local port will act upon flow control
indications received from the far end.
OFF — indicates that the local port will discard flow control
frames received from the far end.
set port disable,
flowcontrol, set port
status, set port speed,
show port edge state
set port duplex,
level, set port name, set port
show port
set port