Ppp Timeout Retry; Pppoe-Client Persistent Delay - Avaya G250 Reference

ppp timeout retry

Use the ppp timeout retry command to set the maximum time to wait for a response
during PPP negotiation. Use the no form of the command to restore the timeout value to its
default.
Syntax
[no] ppp timeout retry seconds
Parameters
Parameter
seconds
User level
read-write
Context
Interface: Serial (DS1 PPP L2-L3, DS1 PPP L2, USP PPP L2-L3, USP PPP L2)
Example
To specify that PPP will wait up to 30 seconds for a response during negotiation:
G350-001(super)# ppp timeout retry seconds
Related commands
encapsulation,

pppoe-client persistent delay

Use the pppoe-client persistent delay command to configure the interval between
pppoe-client dial attempts.
Syntax
pppoe-client persistent delay seconds
Description
The authentication timeout in seconds
ip address, keepalive (PPP), ppp timeout ncp,
Alphabetical listing of CLI commands
Possible Default
Values Value
1-255 2
show interfaces
Issue 1.1 June 2005 353