Example
To set the refresh rate to 15 seconds:
G350-001(super)# set qos rsvp refresh 15
To specify no retry upon failure:
G350-001(super)# set qos rsvp failure noretry
To specify controlled load service:
G350-001(super)# set qos rsvp profile controlled
To enable RSVP:
G350-001(super)# set qos rsvp enable
Related commands
show qos-rtcp
set qos rtcp
Use the set qos rtcp command to permit the setup of RTCP parameters. The parameters
that can be set are enabling or disabling RTCP reporting capability, setting the IP address of the
monitor, setting the reporting period, and defining the listening port number.
Syntax
set qos rtcp {{enable|disable} | monIP ip-address | reportper seconds |
listenport portno}
Parameters
Parameter
enable
disable
ip-address
seconds
portno
Description
Keyword that specifies to enable RTCP
reporting capability
Keyword that specifies to disable RTCP
reporting capability
The IP address of the monitor
The reporting period in seconds
The listening port number
Alphabetical listing of CLI commands
Possible
Values
5-30
1-65535
Issue 1.1 June 2005
Default
Value
5
5005
475