Show Logging File Condition - Avaya G250 Reference

Lldp Configuration
-------------------
Application status: enable
Tx interval: 30 seconds
Tx hold multiplier: 4
Tx delay: 2 seconds
Reinit delay: 2 seconds
Output fields
Name
Application
status
Tx interval
Tx hold
multiplier
Tx delay
Reinit delay
Related commands
set lldp re-init-delay,
tx-interval, set port
vlan-name config

show logging file condition

Use the show logging file condition command to display all conditions that have been
defined for the file output sink.
Syntax
show logging file condition
User level
read-only
Context
general
Description
Whether the LLDP application is enabled or disabled.
The interval at which the device transmits LLDP frames.
The value of the multiplier on the TxInterval that determines the
actual TTL value sent in an LLDP frame.
The minimum delay between successive LLDP frame
transmissions.
The delay in seconds from when a port is set to LLDP " disable " ,
until re-initialization is attempted.
set lldp system-control,
lldp, set port lldp tlv, show
Alphabetical listing of CLI commands
set lldp tx-delay, set lldp
lldp, show port lldp config,
tx-hold-multiplier, set lldp
show port lldp
Issue 1.1 June 2005 643