Rtp-Stat Service; Rtp-Stat Threshold - Avaya G250 Reference

CLI Commands

rtp-stat service

Use the rtp-stat service command to enable the RTP statistics application. Use the no
form of this command to disable the RTP statistics application. By default, the RTP statistics
application is disabled.
Syntax
[no] rtp-stat-service
User Level
Admin
Context
General
Example
To enable the RTP statistics application:
G350-001 (super)# rtp-stat-service
The RTP statistics service is enabled.
To disable the RTP statistics application:
G350-001 (super)# no rtp-stat-service
The RTP statistics service is disabled.
Related commands
rtp-stat clear, rtp-stat
rtp-stat qos-trap-rate-limit,
rtp-stat sessions,

rtp-stat threshold

Use the rtp-stat threshold command to set thresholds for QoS metrics sampled by the
RTP statistics application. An event counter for each metric increments every time the metric
exceeds its threshold during an RTP session. Use the rtp-stat threshold command also
to set thresholds on averages of metrics. When an RTP session terminates, the RTP statistics
application evaluates the average metrics and generates a QoS trap (if QoS traps are
configured) if one or more of them is over its corresponding threshold. See also
event-threshold
382 Avaya G250 and Avaya G350 CLI Reference
event-threshold,
rtp-stat threshold,
show rtp-stat summary,
on page 376.
rtp-stat fault, rtp-stat min-stat-win,
show rtp-stat config,
show rtp-stat thresholds
rtp-stat qos-trap,
show rtp-stat detailed,
rtp-stat
show