Idle-Character - Avaya G250 Reference

idle-character

Use the idle-character command to set the bit pattern used to indicate an idle line. Use the
no form of this command to restore the default value. For E1 and USP interfaces, the default
value is flags. For T1 interfaces, the default is marks.
Syntax
idle-character {flags|marks}
no idle-character
Parameters
Parameter
flags
marks
User level
read-write
Context
Interface: Serial (DS1 PPP L2, DS1 PPP L2-L3, DS1 FR L2, USP PPP L2, USP PPP L2-L3,
USP FR L2)
Example
To set the idle-character to marks:
G350-001(if:Serial 2/1)# idle-character marks
Related commands
bandwidth, ignore
Description
Keyword specifying that flags are
transmitted to indicate an idle line
Keyword specifying that marks are
transmitted to indicate an idle line
dcd, interface serial, invert
Alphabetical listing of CLI commands
Possible
Values
txclock, nrzi-encoding,
Default
Value
transmitter-delay
Issue 1.1 June 2005 209