Ip Access-Group - Avaya G250 Reference

Related commands
ip access-group,
ip access-control-list,

ip access-group

Use the ip access-group command to activate a specific Access Control list for a specific
direction, on the current interface. Use the no form of this command to suspend the Access
Control list for a specific direction.
Note:
You cannot edit the active Access Control list.
Note:
Syntax
ip access-group policy_list_number direction
no ip access-group direction
Parameters
Parameter
policy_list_number
direction
User level
read-write
Context
Interface: Serial (DS1 PPP L2, DS1 PPP L2-L3, DS1 FR-SUB L2, DS1 FR-SUB L2-L3, USP
PPP L2, USP PPP L2-L3), Loopback (L2, L2-L3), FastEthernet (L2, L2-L3), Tunnel (L2, L2-L3),
VLAN (L2, L2-L3)
Example
To enable access control list 310 for outbound packets on the FastEthernet interface:
G350-001(if:FastEthernet 10/2)# ip access-group 310 out
Related commands
ip access-control-list,
show ip access-control-list,
ip policy-list-copy, ip qos-group,
show ip qos-list
Description
The Access Control list number
The direction of the packets to
which the policy is applied.
ip policy-list-copy,
show ip qos-list
Alphabetical listing of CLI commands
ip qos-list, ip
ip qos-group, ip qos-list,
simulate, pre-classification,
Possible Default
Values Value
300-399 300
in, out
ip simulate, pre-classification,
Issue 1.1 June 2005
show
221