Priority-Queue - Avaya G250 Reference

priority-queue

Use the priority-queue command to enable priority queuing mode in a serial or Fast
Ethernet interface. By default, priority queuing is off, and Weighted Fair VoIP Queuing (WFVQ)
is enabled on all Serial interfaces and all Fast Ethernet interfaces for which traffic-shaping is
enabled. If you disable priority queuing by using the no form of the priority-queue
command, WFVQ is re-enabled.
Syntax
[no] priority-queue
User level
read-write
Context
Interface: Serial (DS1 PPP L2-L3, DS1 PPP L2, DS1 FR L2, USP FR L2, USP PPP L2,
USP PPP L2-L3), FastEthernet (L2, L2-L3)
Note:
This command is also used in FastEthernet context when traffic shaping is
Note:
configured.
Example
To enable priority queuing:
G350-001(if:Serial 2/1:1)# priority-queue
Related commands
fair-queue-limit, fair-voip-queue, voip-queue-delay
Alphabetical listing of CLI commands
Issue 1.1 June 2005 359