Linecode (T1) - Avaya G250 Reference

Context
Interface: Controller (E1)
Example
To set the line-code type to ami:
G350-001(controller:5/1)# linecode ami
Related commands
cablelength long,
interface serial,

linecode (T1)

Use the linecode command to specify the type of line-code transmission for the a T1 line. Use
the no form of the command to restore the default line-code value of b8zs.
Note:
Normally the T1 service provider determines which type of line-code is required
Note:
for your T1 circuit.
Syntax
linecode {ami|b8zs}
Parameters
Parameter
ami
b8zs
User level
read-write
Context
Interface: Controller (T1)
cablelength short, channel-group,
ip address, linecode (T1), remote,
Description
Keyword that specifies the Alternate Mode
Inversion line-code type
Keyword that specifies the B8ZS line-code
type
Alphabetical listing of CLI commands
clock source, controller, ds-mode, framing,
show controllers
Possible
Values
Issue 1.1 June 2005
Default
Value
321